Building vectorization / Levels
Levels category in Building vectorization folder sets levels which are used for drawing building models into the CAD file. These settings are used for automatic building vectorization and the Check Building Models tool.
SETTING |
EFFECT |
---|---|
Models to check |
Levels for Roof, Walls, and Base polygons if a model is marked for checking. This is the status after automatic detection. |
Active model |
Levels for Roof, Walls, and Base polygons if a model is active. This is the case if the Check Building Models tool is started and a model is selected in the list of vector models. |
Approved models |
Levels for Roof, Walls, and Base polygons if a model has been approved. This is the status after the model has been checked and approved with the Check Building Models tool. |
On the Spatix platform, a whole building model is always stored on a single level. Roofs, Walls, and Base of a single building populate the same level depending on the building status. Thus, only single level per each setting is available in TerraScan settings.
The setting on Spatix platform corresponds to the Walls level on Bentley platform. Changing Models to check setting on Spatix changes Models to check: Walls setting on Bentley CAD, and the other way around.